Brocade san switch user creation command
Issue the portenable portnumber command, where portnumber is the number of the port you want to enable.Connect to the switch and log in as admin as described in Connect to the Command Line Interface.How do I turn on the port on my Brocade switch? Note: This will put the zone into the Effective Configuration and will be live in production.
To activate the created zoning, run the cfgenable command, entering yes at the prompt. Run the cfgsave command to save the configuration, entering yes at the prompt. version gives version of fabric operating system. If you are going to use an IPv4 IP address, enter the IP address in dotted decimal notation as prompted.Ĭorrespondingly, how do I add zoning to my Brocade switch? Brocade Switch Commands: Check on the case sensitivity using command help ( it will demonstrate all the possible commands) 1. To set the Ethernet IP address use the ipaddrset command.
#BROCADE SAN SWITCH USER CREATION COMMAND PASSWORD#
Log in to the switch using the default password (which is password).log into the switch as user admin and use the version command. To add a range of ports to a VLAN, use the tagged ethernet to command.Īlso, how do I assign an IP address to a Brocade switch? Setting a Static IP address on the Brocade switch All Brocade switches contained within the SAN fabric must have the appropriate Brocade.
You can no longer just plug them in, connect all your SAN devices and it will work. To add a port to that VLAN, so that traffic across that port is tagged for the specified VLAN, use the tagged ethernet command. Brocade 300 SAN Switch - Rack fitting, Setup and Configuration.